Digit Collection And Dial Plan Parameters - AudioCodes Mediant 3000 User Manual

User's Manual
Parameter
Web: Special Digit
Representation
EMS: Use Digit For
Special DTMF
[UseDigitForSpecialDTM
F]

53.11.3 Digit Collection and Dial Plan Parameters

The digit collection and dial plan parameters are described in the table below.
Parameter
Web/EMS: Dial Plan Index
[DialPlanIndex]
[Tel2IPSourceNumberMappi
ngDialPlanIndex]
Version 6.6
Additional examples: 1664wpp102, 66644ppp503, and
7774w100pp200.
Notes:

For this parameter to take effect, a device reset is required.

This parameter can also be configured in a Tel Profile.
Defines the representation for 'special' digits ('*' and '#') that are used
for out-of-band DTMF signaling (using SIP INFO/NOTIFY).

[0] Special = (Default) Uses the strings '*' and '#'.

[1] Numeric = Uses the numerical values 10 and 11.
Digit Collection and Dial Plan Parameters
Defines the Dial Plan index to use in the external Dial Plan file. The
Dial Plan file is loaded to the device as a .dat file (converted using
the DConvert utility). The Dial Plan index can be defined globally or
per Tel Profile.
The valid value range is 0 to 7, where 0 denotes PLAN1, 1 denotes
PLAN2, and so on. The default is -1, indicating that no Dial Plan
file is used.
Notes:

If this parameter is configured to select a Dial Plan index, the
settings of the parameter DigitMapping are ignored.

If this parameter is configured to select a Dial Plan index from
an external Dial Plan file, the device first attempts to locate a
matching digit pattern in the Dial Plan file, and if not found, then
attempts to locate a matching digit pattern in the Digit Map rules
configured by the DigitMapping parameter.

This parameter is applicable also to ISDN with overlap dialing.

For E1 CAS MFC-R2 variants (which don't support terminating
digit for the called party number, usually I-15), this parameter
and the DigitMapping parameter are ignored. Instead, you can
define a Dial Plan template per trunk using the parameter
CasTrunkDialPlanName_x (or in the Trunk Settings page).

This parameter can also be configured in a Tel Profile.

For more information on the Dial Plan file, see 'Dialing Plans for
Digit Collection' on page 531.
Defines the Dial Plan index in the external Dial Plan file for the Tel-
to-IP Source Number Mapping feature.
The valid value range is 0 to 7, defining the Dial Plan index [Plan
x] in the Dial Plan file. The default is -1 (disabled).
For more information on this feature, see 'Modifying ISDN-to-IP
Calling Party Number' on page 535.
749
53. Configuration Parameters Reference
Description
Description
Mediant 3000