Bootp/Tftp Server - AudioCodes Mediant 3000 User Manual

User's Manual
5. Change the default IP address to one that corresponds with your network:
a. Open the Multiple Interface Table page (Configuration tab > VoIP menu >
Network submenu > IP Settings).
b. Select the 'Index' radio button corresponding to the "OAMP + Media + Control"
application type, and then click Edit.
c. Change the IP address, subnet mask, and Default Gateway IP address to
correspond with your network IP addressing scheme.
d. Click Apply, and then click Done to validate your settings.
6. Save your settings to the flash memory with a device reset (see Resetting the Device
on page 517).
7. Disconnect the computer from the device and then reconnect the device to your
network.
2.2

BootP/TFTP Server

You can assign an IP address to the device using BootP/TFTP protocols. This can be done
using the AudioCodes AcBootP utility (supplied) or any standard compatible BootP server.
Note:
Version 6.6
Figure 2-3: IP Settings Page (Single Network Interface)
You can also use the AcBootP utility to load the software file (.cmp) and
configuration file (.ini). For a detailed description of the AcBootP utility, refer
to AcBootP Utility User's Guide.
2. Assigning the OAMP IP Address
31 Mediant 3000