Telnet Parameters; Snmp Parameters - AudioCodes Mediant 3000 User Manual

Enterprise session border controller / voip digital media gateway
Hide thumbs Also See for Mediant 3000:
Table of Contents

Advertisement

User's Manual

53.2.3 Telnet Parameters

The Telnet parameters are described in the table below.
Parameter
Web: Embedded Telnet
Server
EMS: Server Enable
[TelnetServerEnable]
Web: Telnet Server TCP
Port
EMS: Server Port
[TelnetServerPort]
Web: Telnet Server Idle
Timeout
EMS: Server Idle
Disconnect
[TelnetServerIdleDisconn
ect]

53.2.4 SNMP Parameters

The SNMP parameters are described in the table below.
Parameter
Web: Enable SNMP
[DisableSNMP]
[SNMPPort]
EMS: Keep Alive Trap Port
[KeepAliveTrapPort]
[SendKeepAliveTrap]
Version 6.6
Telnet Parameters
Enables the device's embedded Telnet server. Telnet is disabled by
default for security.
[0] Disable (default)
[1] Enable Unsecured
[2] Enable Secured (SSL)
Note: Only the primary Web User Account (which has Security
Administration access level) can access the device using Telnet (see
'Configuring Web User Accounts' on page 69).
Defines the port number for the embedded Telnet server.
The valid range is all valid port numbers. The default port is 23.
Defines the timeout (in minutes) for disconnection of an idle Telnet
session. When set to zero, idle sessions are not disconnected.
The valid range is any value. The default is 0.
Note: For this parameter to take effect, a device reset is required.
SNMP Parameters
Enables SNMP.
[0] Enable = (Default) SNMP is enabled.
[1] Disable = SNMP is disabled and no traps are sent.
Defines the device's local (LAN) UDP port used for SNMP
Get/Set commands.
The range is 100 to 3999. The default port is 161.
Note: For this parameter to take effect, a device reset is required.
Defines the port to which keep-alive traps are sent.
The valid range is 0 - 65534. The default is port 162.
Enables keep-alive traps and sends them every 9/10 of the time
as defined by the NATBindingDefaultTimeout parameter.
[0] = Disable
[1] = Enable
Note: For this parameter to take effect, a device reset is required.
657
53. Configuration Parameters Reference
Description
Description
Mediant 3000

Advertisement

Table of Contents
loading

Table of Contents