AudioCodes Mediant 3000 User Manual page 795

User's Manual
Parameter
Web/EMS: Remove CLI
when Restricted
[RemoveCLIWhenRestr
icted]
Web/EMS: Remove
Calling Name
[RemoveCallingName]
Web: Remove Calling
Name
EMS: Remove Calling
Name For Trunk Mode
[RemoveCallingNameF
orTrunk_x]
Web/EMS: Progress
Indicator to ISDN
[ProgressIndicator2ISD
N_x]
Version 6.6
User-to-
User=3030373435313734313635353b313233343b3834;pd=4

[2] = SIP header format: User-to-User with encoding=hex at the end
and pd embedded as the first byte (according to IETF Internet-Draft
draft-johnston-sipping-cc-uui-03). For example:
User-to-
User=043030373435313734313635353b313233343b3834;
encoding=hex
where "04" at the beginning of this message is the pd.

[3] = Interworks the SIP User-to-User header containing text format
to ISDN UUIE in hexadecimal format, and vice versa. For example:
SIP Header in text format:
User-to-User=01800213027b712a;NULL;4582166;
Translated to hexadecimal in the ISDN UUIE:
303138303032313330323762373132613b4e554c4c3b3435383
23136363b
The Protocol Discriminator (pd) used in UUIE is "04" (IUA
characters).
Note: This parameter is applicable for Tel-to-IP and IP-to-Tel calls.
Determines (for IP-to-Tel calls) whether the Calling Number and Calling
Name IEs are removed from the ISDN Setup message if the
presentation is set to Restricted.

[0] No = (Default) IE's are not removed.

[1] Yes = IE's are removed.
Enables the device to remove the Calling Name from SIP-to-ISDN calls
for all trunks.

[0] Disable = (Default) Does not remove Calling Name.

[1] Enable = Removes Calling Name.
Note: Some PSTN switches / PBXs may not be configured to support
the receipt of the "Calling Name" information. These switches might
respond to an ISDN Setup message (including the Calling Name) with
an ISDN "REQUESTED_FAC_NOT_SUBSCRIBED" failure. This
parameter can be set to Enable (1) to remove the "Calling Name" from
SIP-to-ISDN calls and allow the call to proceed.
Enables the device to remove the Calling Name per trunk for SIP-to-
ISDN calls.

[-1] Use Global Parameter = (Default) Settings of the global
parameter RemoveCallingName are used.

[0] Disable = Does not remove Calling Name.

[1] Enable = Remove Calling Name.
Note: The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
Determines the Progress Indicator (PI) to ISDN, per trunk.

[-1] Not Configured = (Default) The PI in ISDN messages is set
according to the parameter PlayRBTone2Tel.

[0] No PI = PI is not sent to ISDN.

[1] PI = 1; [8] PI = 8: The PI value is sent to PSTN in
Q.931/Proceeding and Alerting messages. Typically, the PSTN/PBX
cuts through the audio channel without playing local ringback tone,
795
53. Configuration Parameters Reference
Description
Mediant 3000