Radius And Ldap Parameters; General Parameters - AudioCodes Mediant 800B User Manual

User's Manual
Parameter
SIP Recording Rules Table
SIP Recording Rules
configure voip > sip-definition
sip-recording sip-rec-routing
[SIPRecRouting]

67.14.2 RADIUS and LDAP Parameters

67.14.2.1

General Parameters

The general RADIUS and LDAP parameters are described in the table below.
Parameter
Use Local Users Database
configure system > mgmt-auth
> use-local-users-db
[MgmtUseLocalUsersDatabase]
Behavior upon Authentication
Server Timeout
configure system > mgmt-auth
> timeout-behavior
[MgmtBehaviorOnTimeout]
Default Access Level
Version 7.2
Defines SIP Recording Routing rules (for siprec).
The format of the ini file table parameter is as follows:
[ SIPRecRouting ]
FORMAT SIPRecRouting_Index =
SIPRecRouting_RecordedIPGroupName,
SIPRecRouting_RecordedSourcePrefix,
SIPRecRouting_RecordedDestinationPrefix,
SIPRecRouting_PeerIPGroupName,
SIPRecRouting_PeerTrunkGroupID, SIPRecRouting_Caller,
SIPRecRouting_SRSIPGroupName;
[ \SIPRecRouting ]
For a description of the table, see 'Configuring SIP Recording Rules'
on page 229.
Table 67-77: General RADIUS and LDAP Parameters
Defines when the device uses the Local Users table or an
LDAP/RADIUS server for authenticating the login credentials
(username-password) of users when logging into the device's
management interface (e.g., Web or CLI).

[0] When No Auth Server Defined = (Default) The device
authenticates the users using the Local Users table in the
following scenarios:

If no LDAP/RADIUS server is configured.

If an LDAP/RADIUS server is configured, but connectivity
with the server is down. If there is connectivity with the
server, the device uses the server to authenticate the user.

[1] Always = The device first attempts to authenticate the user
using the Local Users table. If no user is found (based on the
username-password combination), it attempts to authenticate
the user using the LDAP/RADIUS server.
Defines the device's response when a connection timeout occurs
with the LDAP/RADIUS server.

[0] Deny Access = User is denied access to the management
platform.

[1] Verify Access Locally = (Default) Device verifies the user's
credentials in its Local Users table (local database).
Note: The parameter is applicable to LDAP- and RADIUS-based
management-user login authentication.
Defines the default access level for the device when the
67. Configuration Parameters Reference
Description
Description
1229 Mediant 800B Gateway & E-SBC