AudioCodes Mediant 3000 User Manual page 769

Enterprise session border controller / voip digital media gateway
Hide thumbs Also See for Mediant 3000:
Table of Contents

Advertisement

User's Manual
Parameter
[FramingMethod_x]
Web/EMS: Clock Master
[ClockMaster]
[ClockMaster_x]
Web/EMS: Line Code
[LineCode]
[LineCode_x]
[AdminState]
[TrunkAdministrativeState_x
Version 6.6
[A] T1 FRAMING F4 = T1 4-Frame multiframe.
[B] T1 FRAMING F12 = T1 12-Frame multiframe (D4).
[C] T1 FRAMING ESF = T1 Extended SuperFrame without
CRC6
[D] T1 FRAMING ESF CRC6 = T1 Extended SuperFrame with
CRC6
[E] T1 FRAMING F72 = T1 72-Frame multiframe (SLC96)
[F] T1 FRAMING ESF CRC6 J2 = J1 Extended SuperFrame
with CRC6 (Japan)
Same as the description for parameter FramingMethod, but for a
specific trunk ID (where x denotes the Trunk ID and 0 is the first
Trunk).
Determines the Tx clock source of the E1/T1 line.
[0] Recovered = (Default) Generate the clock according to the
Rx of the E1/T1 line.
[1] Generated = Generate the clock according to the internal
TDM bus.
Notes:
The source of the internal TDM bus clock is determined by the
parameter TDMBusClockSource.
This parameter is applicable only to E1/T1 interfaces.
Same as the description for parameter ClockMaster, but for a
specific Trunk ID (where x denotes the Trunk ID and 0 is the first
Trunk).
Note: This parameter is applicable only to E1/T1 interfaces.
Selects B8ZS or AMI for T1 spans, and HDB3 or AMI for E1
spans.
[0] B8ZS = (Default) B8ZS line code (for T1 trunks only).
[1] AMI = AMI line code.
[2] HDB3 = HDB3 line code (for E1 trunks only).
Same as the description for parameter LineCode, but for a
specific trunk ID (where 0 denotes the first trunk).
Defines the administrative state for all trunks.
[0] = Lock the trunk; stops trunk traffic to configure the trunk
protocol type.
[1] = Shutting down (read only).
[2] = (Default) Unlock the trunk; enables trunk traffic.
Notes:
For this parameter to take effect, a device reset is required.
When the device is locked from the Web interface, this
parameter changes to 0.
To define the administrative state per trunk, use the
TrunkAdministrativeState parameter.
Defines the administrative state per trunk, where x denotes the
769
53. Configuration Parameters Reference
Description
Mediant 3000

Advertisement

Table of Contents
loading

Table of Contents