AudioCodes Mediant 3000 User Manual page 242

Parameter
Web/EMS: Is Proxy
Hot-Swap
[ProxySet_IsProxyH
otSwap]
Web/EMS:
Redundancy Mode
[ProxySet_ProxyRed
undancyMode]
Web/EMS: SRD Index
[ProxySet_ProxySet_
SRD]
Web/EMS:
Classification Input
[ClassificationInput]
User's Manual

SRV is not enabled (DNSQueryType).

The SRV response includes several records with a different Priority
value.
Enables the Proxy Hot-Swap redundancy mode.

[0] No (default)

[1] Yes
If Proxy Hot-Swap is enabled, the SIP INVITE/REGISTER message is
initially sent to the first Proxy/Registrar server. If there is no response from
the first Proxy/Registrar server after a specific number of retransmissions
(configured by the parameter HotSwapRtx), the message is resent to the
next redundant Proxy/Registrar server.
Determines whether the device switches back to the primary Proxy after
using a redundant Proxy.

[-1] Not configured = (Default) The global parameter,
ProxyRedundancyMode applies.

[0] Parking = The device continues operating with a redundant (now
active) Proxy until the next failure, after which it operates with the next
redundant Proxy.

[1] Homing = The device always attempts to operate with the primary
Proxy server (i.e., switches back to the primary Proxy whenever it's
available).
Notes:

To use the Proxy Redundancy mechanism, you need to enable the
keep-alive with Proxy option, by setting the parameter
EnableProxyKeepAlive to 1 or 2.

If this parameter is configured, then the global parameter is ignored.
Defines the SRD associated with the Proxy Set ID.
The default is SRD 0.
Notes:

For this parameter to take effect, a device reset is required.

To configure SRDs, see Configuring SRD Table on page 225.
Defines how the device classifies an IP call to the Proxy Set.

[0] Compare only IP = (Default) The call is classified to the Proxy Set
according to its IP address only.

[1] Compare IP, port and transport type = The call is classified to the
Proxy Set according to its IP address, port, and transport type.
Note: This parameter is applicable only if the IP Group table's parameter,
'Classify by Proxy Set' is set to Enable.
Description
242
Mediant 3000
Document #: LTRT-89729