Configuring Radius Accounting - AudioCodes Mediant 3000 User Manual

User's Manual
48.3

Configuring RADIUS Accounting

The device can send accounting data of SIP calls as call detail records (CDR) to a RADIUS
Accounting server. The device can send the accounting messages to the RADIUS server
upon call release, call connection and release, or call setup and release. For a list of the
CDR attributes, see the table following the procedure below.
Notes:

To configure RADIUS accounting:
1. Open the RADIUS Parameters page (Configuration tab > VoIP menu > SIP
Definitions submenu > RADIUS Parameters Settings).
2. Configure the parameters as required.
3. Click Submit.
4. For your settings to take effect, reset the device with a flash burn.
The table below describes the RADIUS Accounting CDR attributes included in the
communication packets transmitted between the device and a RADIUS server.
Attribute Attribute
Number Name
Request Attributes
1 user-name
4 nas-ip-
address
6 service-type
26 h323-
incoming-
Version 6.6
•
For RADIUS accounting settings to take effect, you must save the
settings to flash memory with a device reset.
•
For a description of the RADIUS accounting parameters, see 'RADIUS
Parameters' on page 680.
Figure 48-3: RADIUS Accounting Parameters Page
Supported RADIUS Accounting CDR Attributes
Vendor
Specific
Attribute
(VSA) No.
- Account number or
calling party number
or blank
- IP address of the
requesting device
- Type of service
requested
1 SIP call identifier
48. Reporting Information to External Party
Value
Purpose
Format
String up
to 15
digits
long
Numeric
Numeric
Up to 32
octets
603
Example AAA
542138574 Start Acc
7 Stop Acc
192.168.14. Start Acc
43 Stop Acc
1: login Start Acc
Stop Acc
- Start Acc
Stop Acc
Mediant 3000