AudioCodes Mediant 3000 User Manual page 287

User's Manual

Proxy Set ID #1 with two FQDN's for ITSP-A

Proxy Set ID #2 with two IP addresses for ITSP-B

Proxy Set ID #3 with an IP address for the IP-PBX

To configure the Proxy Sets:
1. Open the Proxy Sets Table page (Configuration tab > VoIP menu > Control
Network > Proxy Sets Table).
2. Configure Proxy Set ID #1 for ITSP-A:
a. From the 'Proxy Set ID' drop-down list, select 1.
b. In the 'Proxy Address' column, enter the FQDN of ITSP-A SIP trunk Proxy
servers (e.g., "Proxy1.ITSP-A" and "Proxy2. ITSP-A").
c. From the 'Transport Type' drop-down list corresponding to the Proxy addresses
entered above, select TLS.
d. In the 'Enable Proxy Keep Alive' drop-down list, select Using Options, and then
in the 'Proxy Load Balancing Method' drop-down list, select Round Robin.
3. Configure Proxy Set ID #2 for ITSP-B:
a. From the 'Proxy Set ID' drop-down list, select 2.
b. In the 'Proxy Address' column, enter the IP addresses of the ITSP-B SIP trunk
(e.g., "216.182.224.202" and "216.182.225.202").
c. From the 'Transport Type' drop-down list corresponding to the IP address entered
above, select UDP.
Version 6.6
Figure 20-8: Proxy Set ID #1 for ITSP-A
287
20. IP-to-IP Routing Application
Mediant 3000