Basic operator panel (BOP)
6.5 Auxiliary functions
6.5.2
Saving parameters (RAM to ROM)
This function is used for saving a parameter set from the drive RAM to the drive ROM.
To use this function, proceed as follows:
Note
Plugging or unplugging the micro SD card/SD card will cause saving failure.
Do not plug or unplug the micro SD card/SD card during saving; otherwise, the saving
operation will fail.
Note
• If a micro SD card/SD card has been inserted, the parameter set will be saved onto the
micro SD card/SD card simultaneously.
• All signal functions become inactive during the saving process. Use the signal functions
afterwards.
Reference
Editing parameters (Page 118)
6.5.3
Setting parameters to default
This function is used to reset all parameters to their default values.
To reset the parameters to their default values, proceed as follows:
124
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 09/2016, A5E37208830-002