Siemens SIMOTICS S-1FL6 Operating Instructions Manual page 273

Fault
F52983: No encoder detected
Message class: General drive
fault (19)
Reaction: OFF1
Acknowledgement:
IMMEDIATELY
F52984: Incremental encoder
motor not configured
Message class: General drive
fault (19)
Reaction: OFF1
Acknowledgement:
IMMEDIATELY
F52985: Absolute encoder
motor wrong
Message class: General drive
fault (19)
Reaction: OFF1
Acknowledgement:
IMMEDIATELY
F52987: Absolute encoder
replaced
Message class: General drive
fault (19)
Reaction: OFF1
Acknowledgement:
IMMEDIATELY
Alarm list
Alarm
A1009: Control module over-
temperature
Message class: Over-
temperature of the electronic
components (6)
A1019: Writing to the remov-
able data medium unsuccess-
ful
Message class: Over-
temperature of the electronic
component (6)
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 09/2016, A5E37208830-002
Cause
The servo drive in use does not support
encoderless operation.
Commissioning of the servo motor has
•
failed.
The incremental encoder motor is con-
•
nected but fails to commission.
Motor ID is downloaded wrong during
•
manufacture.
The firmware of the servo drive does
•
not support the Motor ID.
Incorrect absolute encoder data.
Cause
The temperature of the control module
(Control Unit) has exceeded the specified
limit value.
The write access to the removable data
medium was unsuccessful.
12.2 List of faults and alarms
Remedy
Check the encoder cable connection be-
•
tween the servo drive and the servo mo-
tor.
Use a servo motor with encoder.
•
Configure the motor ID by setting the parame-
ter p29000.
Update the firmware.
•
Use a correct absolute encoder motor.
•
Contact the Hotline.
Remedy
Check the air intake for the Control Unit.
•
Check the Control Unit fan.
•
Note:
The alarm automatically disappears after the
limit value has been
undershot.
Remove and check the removable data me-
dium. Then run the data backup again.
Diagnostics
273