Siemens SIMOTICS S-1FL6 Operating Instructions Manual page 104

Commissioning
5.2 Commissioning in JOG mode
NOTICE
Existing setting data may be overwritten by the setting data on the micro SD card/SD card
during startup.
• When a drive is switched on with a micro SD card/SD card containing user setting data,
• When a drive is switched on with a micro SD card/SD card containing no user setting
Before starting up the drive with a micro SD card/SD card, check whether the micro SD
card/SD card contains user setting data. Otherwise, the existing data on the drive may be
overwritten.
Note
Plugging or unplugging the micro SD card/SD card will cause startup failure.
Do not plug or unplug the micro SD card/SD card during startup; otherwise, the drive will fail
to start up.
Note
In S control mode, if the motor shaft is blocked, the blocked torque is the current effective
torque. Long time shaft blocking can cause damage to the motor.
Engineering tool - SINAMICS V-ASSISTANT
You can use the engineering tool SINAMICS V-ASSISTANT to perform the trial operation.
SINAMICS V-ASSISTANT is a software tool that can be installed on a PC and runs on the
Windows operating system. It communicates with the SINAMICS V90 PN servo drive with a
USB cable (To ensure the stability of online commissioning, Siemens recommends you to
use a shielded USB cable of no longer than 3 m with ferrite cores on both ends.). With
SINAMICS V-ASSISTANT, you can change drive parameters and monitor drive working
states in online mode.
For more information, refer to SINAMICS V-ASSISTANT Online Help. You can search and
download SINAMICS V-ASSISTANT from Technical support website
(https://support.industry.siemens.com/cs/ww/en/).
104
the existing setting data on the drive will be overwritten.
data, the drive will automatically save the existing user setting data onto the micro SD
card/SD card.
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 09/2016, A5E37208830-002