Profinet Interface - X150 - Siemens SIMOTICS S-1FL6 Operating Instructions Manual

Connecting

4.8 PROFINET interface - X150

Braking sequence
The operating principle of the holding brake is configured during motor selection for motors
with incremental encoders and configured automatically for motors with absolute encoders.
The start of the closing time for the brake depends on the expiration of the shorter of p1227
(zero speed detection monitoring time) and p1228 (pulse suppression delay time).
4.8 PROFINET interface - X150
PROFINET interface
PROFINET devices from the SINAMICS family have a PROFINET interface (Ethernet-
controller/interface) with two ports (physical connection possibilities).
Every PROFINET device on the network is uniquely identified via its PROFINET interface.
For this purpose, each PROFINET interface has:
● A MAC address (factory default)
● An IP address
● A device name (name of the station)
100
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 09/2016, A5E37208830-002