Appendix; Assembly Of Cable Terminals On The Drive Side; A.1 Assembly Of Cable Terminals On The Drive Side - Siemens SIMOTICS S-1FL6 Operating Instructions Manual

Appendix

A.1

Assembly of cable terminals on the drive side

Power terminal assembly
Drive type
200 V FSB
variant
FSC
FSD
400 V FSAA
variant
FSA
400 V FSB
variant
FSC
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 09/2016, A5E37208830-002
Procedure
Terminal assembly procedure:
1. Remove the outer sheath of the ca-
ble.
2. Remove the insulation from the wire.
3. Insert the stripped end into the cable
end sleeve.
4. Crimp the cable end sleeve using a
crimp tool for end sleeves.
Terminal assembly procedure:
1. Remove the outer sheath of the ca-
ble.
2. Remove the insulation from the wire.
3. Insert the stripped end into the spade
terminal.
4. Crimp the spade terminal using a
crimp tool for cable lugs. (Note: Coat
any exposed wires with tin.)
Illustration
A
283