Saving Parameters (Ram To Rom); Setting Parameters To Default - Siemens SINAMICS V90 Operating Instructions Manual

6.5.2

Saving parameters (RAM to ROM)

This function is used for saving a parameter set from the drive RAM to drive ROM.
To use this function, proceed as follows:
NOTICE
Plugging or unplugging the SD card will cause saving failure.
Do not plug or unplug the SD card during saving; otherwise, the saving operation will fail.
Note
• If an SD card has been inserted, the parameter set will be saved onto the SD card
simultaneously.
• All signal functions become inactive during the saving process. Use the signal functions
afterwards.
Reference
Editing parameters (Page 124)
6.5.3

Setting parameters to default

This function is used to reset all parameters to their default values.
To reset the parameters to their default values, proceed as follows:
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 07/2015, 6SL3298-0AV60-0BP0
Basic operator panel (BOP)
6.5 Auxiliary functions
129