Jog - Siemens SIMOTICS S-1FL6 Operating Instructions Manual

6.5.1

JOG

Note
To enable the JOG function, set bit 0 of parameter p29108 to 1, and then save the
parameter setting and restart the drive.
Keep digital signal EMGS at a high level (1) to ensure normal operation.
With the JOG function, you can run the connected motor and view JOG speed or JOG
torque.
To run the connected motor with the JOG function and view the JOG speed, proceed as
follows:
JOG in speed (example)
To run the connected motor with the JOG function and view the JOG torque, proceed as
follows:
JOG in torque (example)
NOTICE
Exit the JOG mode after completing JOG run.
The servo motor cannot run if the servo drive is in the JOG mode.
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 09/2016, A5E37208830-002
Basic operator panel (BOP)
6.5 Auxiliary functions
123