Ping Mpls L2Circuit - Dell PowerConnect J-EX4200-24T Software Manual

ping mpls l2circuit

Syntax
Release Information
Description
Options
ping mpls l2circuit (interface interface-name | virtual-circuit virtual-circuit-id neighbor address)
<count count>
<destination address>
<detail>
<exp forwarding-class>
<logical-system (all | logical-system-name)>
<size bytes>
<source source-address>
<sweep>
<v1>
Command introduced before Junos OS Release 10.2 for J-EX Series switches.
Check the operability of the MPLS Layer 2 circuit connections. Type Ctrl+c to interrupt a
command.
ping mpls l2circuit
count count —(Optional) Number of ping requests to send. If
requests are sent. The range of values is
.
5
destination address —(Optional) Specify an address other than the default (
for the ping echo requests. The address can be anything within the
detail —(Optional) Display detailed information about the echo requests sent and received.
—(Optional) Value of the forwarding class for the MPLS ping packets.
exp forwarding-class
—Ping an interface configured for the Layer 2 circuit on the egress
interface interface-name
provider edge (PE) router.
logical-system (all | logical-system-name)
systems or on the specified logical system.
—(Optional) Size of the label-switched path (LSP) ping request packet (
size bytes
through bytes). Packets are 4-byte aligned. For example, If you enter a size
65468
of 97, 98, 99, or 100, the router or switch uses a size value of 100 bytes. If you enter
a packet size that is smaller than the minimum size, an error message is displayed
reminding you of the 96-byte minimum.
source source-address —(Optional) IP address of the outgoing interface. This address is
sent in the IP source address field of the ping request. If this option is not specified,
the default address is usually the loopback interface (
sweep —(Optional) Automatically determine the size of the maximum transmission unit
(MTU).
—(Optional) Use the type 9 Layer 2 circuit type, length, and value (TLV).
v1
Chapter 125: Operational Mode Commands for MPLS
count is not specified, five ping
through . The default value is
1 1,000,000
—(Optional) Perform this operation on all logical
).
lo.0
127.0.0.1/32 )
subnet.
127/8
96
3145