Verifying The Routing Protocol - Dell PowerConnect J-EX4200-24T Software Manual

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS

Verifying the Routing Protocol

Purpose
Action
Meaning
Verifying the Core Interfaces Being Used for the MPLS Traffic
Purpose
Action
Meaning
Verifying RSVP
Purpose
Action
3116
IP addresses, because the
for the protocol family of the core interfaces (
these interfaces are configured as both
interfaces shows the IP address configured for these interfaces.
Verify the state of the configured routing protocol. You should perform this verification
task on each of the switches. The state should be
the routing protocol, use the
protocol is communicating with the switch neighbors. If you have configured IS-IS as the
routing protocol, use the
show isis adjacency
is communicating with the switch neighbors.
user@switch> show ospf neighbor
Address Interface
127.1.1.2 ge—0/0/5
The show ospf neighbor command displays the status of the routing protocol that has
been configured on this switch. The output shows that the state is
routing protocol is operating correctly—that is, hello packets are being exchanged between
directly connected neighbors. For additional information on checking and monitoring
routing protocols, see the Junos OS Routing Protocols and Policies Command Reference
at
http://www.juniper.net/techpubs/software/junos/
Verify that the state of the MPLS interface is
task on each of the switches.
user@switch> show mpls interface
Interface State
ge—0/05 Up
The command displays the status of the core interfaces that have
show mpls interface
been configured to belong to
to belong to family mpls is
Verify the state of the RSVP session. You should perform this verification task on each
of the switches.
user@switch> show rsvp session
Ingress RSVP: 1 sessions
To From
127.1.1.3 127.1.1.1
lsp_to_pe2_ge1
Total 1 displayed, Up 1, Down 0
inet family is not configured for CCC interfaces. The output
ge-0/0/0.5
and
inet mpls
Full
show ospf neighbor command to verify that the routing
command to verify that the routing protocol
State
Full
.
. You should perform this verification
Up
Administrative groups
<none>
. This output shows that the interface configured
family mpls
up .
State Rt Style Labelin Labelout LSPname
Up 0
and ge-0/0/0.6 ), shows that
. The column for the core
Local
. If you have configured OSPF as
ID Pri
10.10.10.10 128
full , meaning that the
1 FF - 300064
Dead
39