Safety Summary - Tektronix MSO70000/C Series User Manual

Appendix
Table 3: Certifications and compliances (cont.)
Characteristics
Measurement Category
Descriptions
Pollution Degree 2
Additional Safety Standards
Equipment Recycling. This product complies with the European Union's requirements according to Directive
2002/96/EC on waste electrical and electronic equipment (WEEE). For more information about recycling
options, check the Support/Service section of the Tektronix Web site (www.tektronix.com).

Safety Summary

Review the following safety precautions to avoid injury and prevent damage to this product or any products connected to it.
To avoid potential hazards, use this product only as specified. Using the probe or accessories in a manner not specified
could result in a shock or fire hazard.
To Avoid Fire or Personal Injury
Ground-Referenced Oscilloscope Use.
referenced oscilloscopes (for example, DPO, MSO, and TDS series oscilloscopes). The reference lead must be connected to
earth potential (0 V).
Connect and Disconnect Properly.
probe to the circuit under test. Disconnect the probe input and the probe reference lead from the circuit under test before
disconnecting the probe from the measurement instrument.
Avoid Electric Shock.
are connected to a voltage source.
Observe All Terminal Ratings.
the product manual for further ratings information before making connections to the product.
Avoid Electric Shock.
whichever is less, including the measurement category and voltage rating.
Avoid Electric Overload.
inputs, that varies from ground by more than the maximum rating for that input.
Avoid Exposed Circuitry and Do not Operate Without Covers.
components when power is present.
176
Description
Category
CAT III
CAT II
CAT I
Do not operate in environments where cond–
uctive pollutants may be present (as defined in IEC 61010-1). Rated for indoor use only.
UL61010B-1, First Edition & UL61010B-2-031, First Edition.
CAN/CSA-C22.2 No. 1010.1-92, & CAN/CSA-C22.2 No. 1010.2.031-94
IEC61010-031:2002
Do not float the reference lead of this probe when using with ground
Connect the probe output to the measurement instrument before connecting the
To avoid injury or loss of life, do not connect or disconnect probes or test leads while they
To avoid fire or shock hazard, observe all ratings and markings on the product. Consult
When using probe accessories, never exceed the lowest rating of the probe or its accessory,
To avoid injury or fire hazard, do not apply potential to any input, including the reference
MSO70000/C, DPO/DSA70000B/C, DPO7000, and MSO/DPO5000 Series User Manual
Examples of Products in this Category
Distribution-level mains, fixed installation
Local-level mains, appliances, portable equipment
Circuits not directly connected to mains.
Do not touch exposed connections and