Table of Contents
Advertisement
KingKORG NEO Parameter Guide
3 .
Parameters transmitted and
received via NRPN
Front panel knobs and buttons other than the controls listed above are
assigned NRPN (Non Registered Parameter No.). NRPN messages can be
used freely by any musical instrument manufacturer or model.
NRPN editing is performed using the following procedure.
1.
Use NRPN MSB (CC#99) [Bn, 63, mm] and NRPN LSB (CC#98) [Bn,
62, rr] (n: channel, mm, rr: parameter no. upper and lower bytes) to
select the parameter.
2.
Use data entry MSB (CC#6) [Bn, 06, mm] (n: channel, mm:
parameter value) to specify the value.
TIP:
On the KingKORG NEO, only data entry MSB is used.
Controlling the arpeggiator
When arpeggiator settings are modified by the front panel buttons or knobs,
the following NRPN messages are transmitted. When these NRPN messages
are received, the corresponding arpeggiator settings will change accordingly.
These messages are transmitted and received on the Global MIDI channel.
For the correspondence between the values of the message and the values of
the KingKORG NEO parameter, refer to the table.
Arp SW
Arp SW: [Bn, 63, 00, Bn, 62, 02, Bn, 06, mm]
(n: channel, mm: parameter value)
MSB (Hex)
LSB (Hex)
Arp SW
00 (00)
02 (02)
Controlling the vocoder parameters
These messages are transmitted and received on the Global MIDI channel.
Vocoder SW
Vocoder SW: [Bn, 63, 05, Bn, 62, 04, Bn, 06, mm]
(n: channel, mm: parameter value)
MSB (Hex) LSB (Hex)
Vocoder SW
05 (05)
04 (04)
Other controls
These messages are transmitted and received on the Global MIDI channel.
VoiceMode (Common page "VoiceMode")
VoiceMode: [Bn, 63, 05, Bn, 62, 00, Bn, 06, mm]
(n: channel, mm: parameter value)
MSB
LSB
(Hex)
(Hex)
VoiceMode
05 (05)
00 (00)
Value
Value (received)
(transmitted)
0: OFF
0...63: OFF
127: ON
64...127: ON
Value
Value (received)
(transmitted)
0: Off
0...63: OFF
127: On
64...127: ON
Value
Value (received)
(transmitted)
0: SINGLE
0...42: Single
43: LAYER
43...84: Layer
85: SPLIT
85...127: Split
4 .
System exclusive messages
KingKORG NEO format
F0
exclusive status
42
Korg ID
3n
[n=0–F] MIDI channel
00 01 18
KingKORG NEO model ID
ff
function ID (type of message)
F7
end of exclusive
Universal system exclusive
System exclusive messages include a special category of messages whose
purpose is officially defined. These are called universal system exclusive
messages. Of these universal system exclusive messages, the
KingKORG NEO supports Master Volume and Master Fine Tuning.
Master volume [F0, 7F, nn, 04, 01, vv, mm, F7]
(vv: lower byte of value, mm: upper byte of value, [mm, vv=7F, 7F] is Max,
[mm, vv=00, 00] is 0)
When a Master Volume message is received, the KingKORG NEO will
adjust its overall volume.
Master fine tuning [F0, 7F, nn, 04, 03, vv, mm, F7]
(A value of 8192 [mm, vv=40, 00] is center (0 cent, A4=440.0Hz), 4096
[mm, vv=20, 00] is -50 cents, and 12288 [mm, vv=60, 00] is +50 cents).
When a master fine tune message is received, the KingKORG NEO's
GLOBAL "g01: Common" page Mst. Tune setting will be ignored, and the
overall pitch will be specified by the received data.
5 .
Realtime Messages
Controlling the arpeggiator and LFOs
When the KingKORG NEO's tempo is synchronized to MIDI clock data from an
external device, you can use system realtime messages to control the
functionality of the arpeggiator and LFOs
Start [FA]
When the start message [FA] is received, the arpeggio will be reset to the
beginning of the pattern. Additionally, if the LFO's Key Sync is turned off, the
phase of the LFO will be reset.
Stop [FC]
When a Stop [FC] message is received, the arpeggiator will stop. (It will not be
turned off; the arpeggiator will start again when additional notes are played).
- 33 -
MIDI
—
(→ p.19
"Clock").
Advertisement
Table of Contents
