Easy Program Editing; Using The Tone Adjust And Eg Adjust Functions - Korg KROSS Operation Manual

Easy program editing

Using the Tone Adjust and EG Adjust
functions
The fastest way to create the sound you need is to find a
preload program that's close to what you want, and then
modify its settings to your taste.
On the PROG> TONE page you can edit the sound's most
important parameters, such as cutoff frequency, resonance,
attack time, and release time.
1. Access the PROG> TONE page.
Press the PROG button. Next, press the PAGE+ button or
PAGE- button to access the PROG>TONE page.
2. Use the cursor buttons ◄►▲▼ to select the
parameter that you want to edit.
3. Use the VALUE dial etc. to edit the value.
Tone Adjust (Filter): Tone Adjust (Amp):
Brightness of the Volume change
sound produced by your
keyboard dynamics
Tone Adjust controls
Note: When the Tone Adjust controls are at +00, the
program parameters will have their original values.
Cutoff
This adjusts the filter's cutoff frequency. Adjusting the
cutoff frequency will modify the brightness of the sound.
Resonance
This adjusts the filter's resonance level.
Adjusting the filter resonance level will boost the sound in
the region of the frequency, giving a distinctive character to
the sound.
In the case of a Low Pass Filter
Level
Frequency
Cutoff
Low High
EG Adjust: Time-varying change
in volume and brightness
Resonance
Easy program editing Using the Tone Adjust and EG Adjust functions
EG Intensity
This adjusts the filter EG intensity (the depth of how the EG
affects the filter). Normally, increasingly negative values
("–" settings) will make the filter EG have a shallower
effect, and increasingly positive values ("+" settings) will
make it have a deeper effect. Since the filter EG operates
relative to the filter cutoff frequency, the tonal change
produced by the filter will be affected both by Cutoff and by
EG Intensity.
Level
Vel. Intensity
Adjusts the velocity intensity for the amp level.
With a setting of –99, velocity will no longer produce any
change at all. A setting of +99 will produce maximum
change in the same direction (positive or negative) as for the
original program.
EG Adjust controls
Note: With an adjustment of +00, the value of the program
parameters will be unchanged.
Attack
Adjusts the EG attack times of the filter and amp
simultaneously. This sets the time from note-on until the
attack level is reached. Increasingly negative values ("–"
settings) will shorten the attack time, and increasingly
positive values ("+" settings) will lengthen it.
Level
note-on note-off
Sustain
Level
0
Attack Decay
Time Time
Decay
Adjusts the EG decay times of the filter and amp
simultaneously. This sets the time from when the attack level
is reached until the break level is reached. Increasingly
negative values ("–" settings) will shorten the decay time,
and increasingly positive values ("+" settings) will lengthen
it.
Sustain
Adjusts the EG sustain level that follows the decay/slope
time, for both the filter and amp simultaneously. This
specifies the level that is reached after the decay time has
elapsed, and is held until note-off. Increasingly negative
values ("–" settings) will lower the sustain level, and
increasingly positive values ("+" settings) will raise it.
Release
Adjusts the EG release times of the filter and amp
simultaneously. This specifies the time from note-off until
the sound disappears. Normally, negative settings will
shorten the release time, and positive settings will lengthen it.
Time
Time
Release
Time
31