Table of Contents
Advertisement
5
Set the Auto-assign DNs check box according to the requirements of your installation (if set,
the SRG50 automatically assigns DNs; refer to BCM50 Device Configuration Guide for
details).
Local mode indication
When an IP telephone is in local mode, a message is displayed on the phone to indicate the local
mode state to the user. The default setting is Local Mode.
To change local mode indication
1
On the SRG50 Element Manager, navigate to Configuration > Resources > Telephony
Resources.
2
Select the IP & Application Sets row
3
On the Details for Module: Internal subpanel, select the IP Terminal Global Settings tab.
4
The Advertisement/Logo field specifies the message that provides local mode indication.
Change as required.
IP telephone codec and jitter settings
When the IP telephones are operating in local mode, codec and jitter settings are set on a
phone-by-phone basis. Configure the settings to meet the requirements of the local SRG50
environment. They do not have to be the same as the main office settings (in contrast to the QoS
settings for the VoIP trunks; refer to
page
80).
To enter codec and jitter settings for IP telephones in local mode
1
On the SRG50 Element Manager, navigate to Configuration > Resources > Telephony
Resources.
2
On the Modules panel, locate the Module type column and select the IP & Application Sets
row
(Figure
3
On the Details for Module: Internal subpanel, select the IP Terminal Global Settings tab.
The fields related to QoS are on the right side of the panel.
4
Enter the appropriate values.
"QoS settings (codec, jitter buffer, and related items)" on
10).
Chapter 5 Setting up IP telephones
(Figure
9).
Survivable Remote Gateway 50 Configuration Guide
65
Advertisement
Table of Contents
Troubleshooting
