Copy Port Attributes - ZyXEL Communications MS-7206 User Manual

[ttl <1-255>]
[wait <1-60>]
[queries <1-10>]
This command displays information about the route to an Ethernet device. The following
example displays route information to an Ethernet device with an IP address of
192.168.1.100
sysname> traceroute 192.168.1.100
traceroute to 192.168.1.100, 30 hops max, 40 byte packet
1:192.168.1.100 (10 ms) (10 ms) (0 ms)
traceroute done:
sysname>

47.5 Copy Port Attributes

Use the
copy running-config
ports.
Syntax:
copy running-config interface port-channel <port> <port-list>
copy running-config slot <slot> <slot-list>
-> [active] [name] [speed-duplex] [bpdu-control] [flow-control]
-> [intrusion-lock] [vlan1q] [vlan1q-member] [bandwidth-limit]
-> [vlan-stacking] [port-security] [broadcast-storm-control] [mirroring]
-> [port-access-authenticator] [queuing-method] [igmp-filtering]
-> [spanning-tree] [mrstp] [port-based-vlan]
where
copy running-config
interface port-channel
<port> <port-list>
copy running-config
interface port-
channel <port>
<port-list>
...]
copy running-config
slot <slot> <slot-
list>
copy running-config
interface
<slot-list> [active
...]
An example is shown next.
• Copy all attributes of port 1 to port 2 in slot 4.
MS-7206 User's Guide
= Specifies the Time To Live (TTL) period.
= Specifies the time period to wait.
= Specifies how many tries the switch performs the traceroute
function.
.
command to copy attributes of one port to another port or
= Copies all of the possible attributes from one port to another port
or ports.
= Copies only the specified attributes from one port to another port
or ports.
[active
= Copies all of the possible attributes from one slot to another slot or
slots.
= Copies only the specified attributes from one slot to another slot
slot <slot>
or slots.
Chapter 47 User and Enable Mode Commands
287