Electromagnetic Approvals; Port Specifications For All Router Models; 2X100Gbe Cfp2 Dynamic Port Configuration; Console Port Pin Assignments - Brocade Communications Systems NetIron MLXe Series Hardware Installation Manual

Electromagnetic approvals

• FCC Part 15, Subpart B (Class A)
• EN 55022 (CE mark) (Class A)
• EN 55024 (CE mark) (Immunity) for Information Technology Equipment
• ICES-003 (Canada) (Class A)
• AS/NZ 55022 (Australia) (Class A)
• VCCI (Japan) (Class A)
• EN 61000-3-2
• EN 61000-3-3
• EN 61000-6-1

Port specifications for all router models

This section describes port specifications for all router models.

2x100GbE CFP2 Dynamic Port Configuration

The dynamic port configuration is shown for the 2x100GbE CFP2 based high density blade chassis.
Dynamic port configuration for the 20x10/1GbE based high density blade chassis is shown in the following table.
TABLE 54 20x10/1GbE Module Dynamic Port Configuration
# Ports Line Speed
20 1GbE
10GbE
10GbE
1GbE
10GbE

Console port pin assignments

The console port is a standard male DB-9 connector, as shown in the following figure. For information about how you can use this port,
refer to Console port on page 31.
FIGURE 124 Console port pin and signaling details
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04
SFP Type Configuration Status
SFP 1GbE
SFP+ 10GbE
SFP 10GbE
SFP+ 1GbE
SFP+ 1GbE
Port specifications for all router models
Port Speed Status
Supported
Supported
Not Supported
Not Supported
Not Supported
275