Brocade Communications Systems NetIron MLXe Series Hardware Installation Manual page 242

IPv6 ND Proxy
6to4_tnl tunnel-id
Specifies IPv6 to IPv4 tunnel number to be used as next hop.
ipv6_tnl tunnel-id
Specifies IPv6 tunnel to be used as next hop.
name string
Optional name (ASCII string) assigned to the route
metric
Specifies a value that the Layer 3 switch uses to compare this route to other static routes in the IPv6 static route table
that have the same destination. The metric applies only to routes that the Layer 3 switch has already placed in the IPv6
static route table. Two or more routes to the same destination with the same metric will load share (as in ECMP load
sharing). The range is from 1 through 16. The default is 1.
distance number
Specifies an administrative distance. The range is from 1 through 255. The default is 1. This is a value that the Layer 3
switch uses to compare this route with routes from other route sources that have the same destination. By default,
static routes take precedence over routes learned by routing protocols. To choose a dynamic route over a static route,
configure the static route with a higher administrative distance than the dynamic route.
tag
Specifies a tag value for the route. The route tag can be used for route redistribution to routing protocols by means of
route maps (as in IPv4 static route redistribution).
tag-number
Modes
Global configuration mode
VRF configuration mode
Usage Guidelines
The no form of the command removes the IPv6 static route. If the route is named, the no command must be used twice, the
first time to remove the name and the second time to remove the route.
242
A number from 0 through 4294967295. The default is 0.
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04