Follow these steps to connect a DC power source.
1.
Use a #1 Phillips screwdriver to remove the screw that secures the safety cover, as shown in the following figure. Remove the
safety cover.
FIGURE 88 Removing the safety cover (2400W power supply and 3000W power supply displayed)
2.
Use a #2 Phillips screwdriver to unscrew the power lugs. Refer to the following figure.
FIGURE 89 Removing the power lugs (2400W power supply and 3000W power supply displayed)
1.
Power lug screws
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04
Installing a Brocade MLXe Series-32 router
2.
Power lug
169