Brocade Communications Systems NetIron MLXe Series Hardware Installation Manual page 110

Installing a Brocade MLXe Series-8 router
Follow these steps to connect a DC power source.
1. Use a #1 Phillips screwdriver to remove the two screws that hold the transparent cover over the power supply lugs, as shown in
one of the two following figures (dependent on the power supply).
FIGURE 37 The Brocade MLXe Series DC 1200W power supply
1. Screws holding transparent cover
FIGURE 38 The Brocade MLXe Series DC 1800W power supply
1. Screws holding transparent cover
2. Use a #2 Phillips screwdriver to remove the power lugs.
110
2. Power lug screws
2. Power lug screws
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04