Brocade Communications Systems NetIron MLXe Series Hardware Installation Manual page 40

Router modules
TABLE 11 2x100GbE CFP2 P2010 Specifications (continued)
Component
Security Engine
DDR Support
2x100GbE CFP2 DDR3 SDRAM memory specifications
DDR3 SDRAM memory for the 2x100GbE CFP2 optics based high density blade, is shown in the following table.
TABLE 12 2x100GbE CFP2 DDR3 SDRAM Memory Specifications
Feature
DDR type
DDR size
Data rate
BR-MLX-10GX20-X2 and BR-MLX-100GX2-CFP2-X2 Router Software
BR-MLX-10GX20-X2 and BR-MLX-100GX2-CFP2-X2 scalability for IPv4 and IPv6 routes
In release 5.8.00a, the maximum number of routes supported with the BR-MLX-10GX20-X2 and BR-MLX-100GX2-CFP2-X2
modules has been scaled to 2.4M for IPv4 and 1.8M for IPv6. The -X2 scaling software is compatible with both MR2-M and MR2-X
management modules so that you can deploy M, X, and -X2 modules in the same device.
NOTE
MR2 management modules require High Speed Switch Fabric modules.
40
Gen 2 Cards
512KB L2 cache
Yes
DDR/DDR2
Gen 2 Cards
DDR2
2 GB
Up to 533 Mbps
2x100GbE CFP2 Cards
512KB L2 cache
Yes, enhanced SEC2 Interface
DDR2/DDR3
2x100GbE Cards
DDR3
4GB
NOTE
For NetIron 5.7 release only: 2GB of
SDRAM memory is usable out of
4GB.
Up to 800 Mbps
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04