Table of Contents
Advertisement
Managing Routers and Modules
•
Managing the device..................................................................................................................................................................................... 201
•
Managing switch fabric modules............................................................................................................................................................. 209
•
Managing the cooling system................................................................................................................................................................... 211
•
Managing interface modules..................................................................................................................................................................... 219
•
Monitoring Link Status................................................................................................................................................................................. 225
•
Traffic Manager XPP link monitoring......................................................................................................................................................227
•
Using alarms to collect and monitor device status...........................................................................................................................228
•
Displaying MR2 management module memory usage................................................................................................................ 233
•
Enabling and disabling management module CPU usage calculations..................................................................................233
•
Displaying management module CPU usage....................................................................................................................................235
•
Removing MAC address entries.............................................................................................................................................................. 235
•
IPv6 ND Proxy.................................................................................................................................................................................................236
•
DRBG Health Test on IPsec LP............................................................................................................................................................... 243
Managing the device
You can perform these management tasks for the router:
•
Enable and disable a DC power source, if necessary.
•
Display status and temperatures of all hardware components.
•
Display the Syslog configuration and static and dynamic buffers.
•
Disable and re-enable power to interface modules.
Disabling and re-enabling power to interface modules
You can disable power and re-enable power to all interface modules, or to a specified interface module using the power-off command in
the CLI, as shown in the following example:
device# power-off lp all
Syntax: power-off lp [all|slot-number ]
•
all - disables power to all interface modules
•
slot-number - disables power to the interface module in the specified slot. You can specify 1-4 for 4-slot routers, 1-8 for 8-
slot routers, 1-16 for 16-slot routers, and 1-32 for 32-slot routers.
NOTE
It is recommended that you do not disable power to interface modules during a software upgrade. If you try to disable power
during a software upgrade, the following message will be displayed:Warning: There is an outstanding software
download.Do you want to continue ? (enter "y" or "n") Type "n " and wait until the upgrade is complete.
To re-enable power to all interfaces or to a specific interface, enter the power-on lp command, as shown in this example:
device# power-on lp
Syntax: power-on lp [slot-number|all ]
•
all - enables power to all interface modules
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04
201
Advertisement
Table of Contents
