Brocade Communications Systems NetIron MLXe Series Hardware Installation Manual page 216

Managing the cooling system
TABLE 44 Associations between show chassis, show fan threshold, and fan-threshold commands (continued)
show chassis command output (sensors)
LP Modules (1 or 2 Traffic Managers)
LP Sensor 1 reading (TM 0)
LP Sensor 2 reading (TM 0)
LP Sensor 3 reading (TM 1)
LP Sensor 4 reading (TM 1)
NI-MLX-10Gx8-M LP Modules
LP2 Sensor 1 reading
LP2 Sensor 2 reading
LP2 Sensor 3 reading
LP2 Sensor 4 reading
LP2 Sensor 5 reading
LP2 Sensor 6 reading
LP2 Sensor 7 reading
BR-MLX-100Gx2-X LP Modules
LP2 Sensor 1 reading
LP2 Sensor 2 reading
LP2 Sensor 3 reading
LP2 Sensor 4 reading
LP2 Sensor 5 reading
LP2 Sensor 6 reading
LP2 Sensor 7 reading
LP2 Sensor 8 reading
LP2 Sensor 9 reading
LP2 Sensor 10 reading
LP2 Sensor 11 reading
LP2 Sensor 12 reading
Changing the temperature polling interval
By default, the router reads the temperature sensor on each module every 60 seconds. To change the polling interval, enter the temp-
poll-period command at the global CONFIG level of the CLI.
device(config)# temp-poll-period 120
Syntax: temp poll period log threshold seconds
For the seconds parameter, you can specify a value from 30 - 120.
NOTE
Adjusting temperature polling interval out of the default setting can negatively affect the efficient cooling of blades and may
cause a blade to overheat and shutdown.
216
show fan-threshold command output (thermal
block)
THERMAL_SENSOR_TEST_RULE_LP
THERMAL_SENSOR_TEST_RULE_LP_XPP
THERMAL_SENSOR_TEST_RULE_LP
THERMAL_SENSOR_TEST_RULE_LP_XPP
THERMAL_SENSOR_TEST_RULE_LP_2
THERMAL_SENSOR_TEST_RULE_LP_XPP2
UNUSED
THERMAL_SENSOR_TEST_RULE_LP_2
THERMAL_SENSOR_TEST_RULE_LP_XPP2
UNUSED
UNUSED
THERMAL_SENSOR_TEST_RULE_LP_2
THERMAL_SENSOR_TEST_RULE_LP_XPP2
UNUSED
THERMAL_SENSOR_TEST_RULE_LP_2
THERMAL_SENSOR_TEST_RULE_LP_XPP2
UNUSED
UNUSED
UNUSED
UNUSED
UNUSED
UNUSED
UNUSED
fan-threshold command configuration
fan-threshold lp
N/A (Must not be changed)
fan-threshold lp
N/A (Must not be changed)
fan-threshold lp2
N/A (Must not be changed)
UNUSED
fan-threshold lp2
N/A (Must not be changed)
UNUSED
UNUSED
fan-threshold lp2
N/A (Must not be changed)
UNUSED
fan-threshold lp2
N/A (Must not be changed)
UNUSED
UNUSED
UNUSED
UNUSED
UNUSED
UNUSED
UNUSED
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04