Brocade Communications Systems NetIron MLXe Series Hardware Installation Manual page 254

Replacing a power supply
3. Remove the power supply from the device:
• For a 4-slot device: Use the screwdriver to loosen the two screws on both sides of the power supply faceplate. Then pull
the ejectors forward until the power supply disconnects from the backplane.
• For an 8-slot or 16-slot device: Pull up on the plunger on the faceplate and pull the handle toward you until the power
supply is released.
• For a 32-slot device: Make sure the captured screw underneath the latch handle on the power supply faceplate is loose.
Pull down on the latch handle and curl your fingers over the handle. Pull the handle straight out toward you to unlock the
power supply (see the following figure).
Pull the power supply out of the device.
FIGURE 110 Removing and replacing a power supply in a 32-slot device.
1 Power supply indicators
2 AC power input LED (AC OK)
3 DC power output LED (DC OK)
4 Alarm LED (ALM)
254
5 Latch handle open
6 Lift up latch handle to lock
7 & 8 Power supply blank cover
9 Power supply
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04