Brocade Communications Systems NetIron MLXe Series Hardware Installation Manual page 167

2. Remove the power supply from the packaging.
3. Insert the power supply into the slot, using the guides on each side of the slot, as shown in the following figure.
FIGURE 86 Installing a power supply in a Brocade MLXe Series-32 router
1. Power supply indicators
2. AC power input LED (AC OK)
3. DC power output LED (DC OK)
4. Alarm LED (ALM)
5. Latch handle open
CAUTION
Carefully follow the mechanical guides on each side of the power supply slot and make sure the power supply is
properly inserted in the guides. Never insert the power supply upside down.
4. Push the power supply front panel toward the back of the router to engage the backplane connector.
5. Pull the release latch on the power supply front panel up to lock the power supply in place.
6. Use a #2 Phillips to screw the locking screw into place.
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04
Installing a Brocade MLXe Series-32 router
6. Lift up latch handle to lock
7. Power supply blank cover
8. Power supply blank cover
9. Power supply
167