Brocade Communications Systems NetIron MLXe Series Hardware Installation Manual page 38

Router modules
TABLE 10 2x100GbE CFP2 Chassis Support (continued)
Ports
CFP2 optics for 2x100GbE
The 2x100GbE CFP2 interface module is 802.3ba compliant, supports CFP2-based optics, and can be used with existing Brocade
MLXe Series interface modules. The 2x100GbE interface module requires high-speed fabric modules.
NOTE
2x100GbE CFP2 interface modules will boot in turbo mode if all modules in the chassis are Gen-2 modules.
You must insert CFP2-compliant fiber-optic transceivers in each port you intend to use. CFP2-compliant transceivers provide an optical
or physical medium-dependent (PMD) interface for single- or multi-mode fiber that can be used with either the LAN physical layer (PHY)
or WAN physical layer (WAN PHY).
For a list of supported 2x100GbE CFP2-compliant fiber-optic transceivers that are available from Brocade, refer to the latest version of
the Brocade Optics Family Data Sheet.
For more information about fiber-optic transceivers and associated cabling, refer to
Power supply requirements for 2x100GbE modules
For power supply requirements for the 2x100GbE modules, refer to
38
Chassis Supported
Hardware Specifications
Description
NOTE
XMR not supported.
Installing a fiber-optic transceiver
on page 271.
Brocade NetIron MLXe Series Hardware Installation Guide
on page 197.
53-1004203-04