Brocade Communications Systems NetIron MLXe Series Hardware Installation Manual page 223

Configuring an automatic boot from the auxiliary flash slot on the management module
To configure an automatic boot for all interface modules from auxiliary flash slot1 on the management module, enter the following
command at the global CONFIG level of the CLI.
device(config)# lp boot system slot1 primary all
Syntax: lp boot system [ slot1 | slot2 ] filename [all | slot-number ]
• The slot1 and slot2 keywords indicate the auxiliary flash slot on the management module from which to boot the interface
modules.
• The filename parameter specifies the name of the image from which to boot the interface modules.
• The all | slot-number parameter specifies that the automatic boot applies to all interface modules in the device or to an interface
module in the specified device slot number only. You can specify 1 - 4 for 4-slot devices, 1 - 8 for 8-slot devices, 1 - 16 for
16-slot devices, or 1 - 32 for 32-slot devices.
Configuring an automatic boot from flash memory on the management module
To configure an automatic boot from the primary image in flash memory on the management module for all interface modules, enter the
following command at the global CONFIG level of the CLI.
device(config)# lp boot system mp primary all
Syntax: lp boot system mp [ primary | secondary ] [ all | slot-number ]
• The primary and secondary keywords specify the primary or secondary image in flash memory on the management module.
• The all | slot-number parameter specifies that the automatic boot applies to all interface modules in the device, or to an interface
module in the specified device slot number only. You can specify 1 - 4 for 4-slot devices, 1 - 8 for 8-slot devices, 1 - 16 for
16-slot devices, or 1 - 32 for 32-slot devices.
Configuring an automatic boot from flash memory on the interface module
To configure an automatic boot from the primary image in flash memory on the interface module for all interface modules, enter the
following command at the global CONFIG level of the CLI.
device(config)# lp boot system flash primary all
Syntax: lp boot system flash [ primary | secondary ] [ all | slot-number ]
• The primary and secondary keywords specify the primary or secondary image in the interface module flash memory.
• The all | slot-number parameter specifies that the automatic boot applies to all interface modules in the device or to an interface
module in the specified slot number only. You can specify 1 - 4 for 4-slot devices, 1 - 8 for 8-slot devices, 1 - 16 for 16-slot
devices, or 1 - 32 for 32-slot devices.
Configuring an automatic boot from a TFTP server
To configure an automatic boot for all interface modules from a TFTP server, enter the following command at the global CONFIG level
of the CLI.
device(config)# lp boot system tftp 123.123.123.123 primary all
Syntax: lp boot system tftp ip-addressfilename [ all | slot-number ]
• The ip-address parameter specifies the IP address of the TFTP server from which the interface modules will be booted.
• The filename parameter specifies the name of the image from which to boot the interface modules.
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04
Managing interface modules
223