Applying Seals To Brocade Devices - Brocade Communications Systems FCX 624S Manual

Applying seals to Brocade devices

Seal placement varies by switch model. This section includes the following FIPS seal application procedures:
•
Applying seals to Brocade FCX 624S-F, Brocade FCX 624S, and Brocade FCX 624S-HPOE
•
Applying seals to Brocade FCX 648S and Brocade FCX 648S-HPOE devices
•
Applying seals to Brocade FastIron SX 800 devices
•
Applying seals to Brocade FastIron SX 1600 devices
NOTE
The figures in this document show transparent representations of the seals to show the specific openings
or fasteners that the seals are designed to cover. The actual seals are opaque.
To apply security seals, ensure that the following requirements are met:
•
Carefully remove the seals from the backing and place them on the device. Do not use bare fingers to handle
the labels. Using tweezers, peel away the backing slowly and carefully to avoid contaminating or disturbing the
adhesive.
•
When applying a seal to the device, use firm pressure across the surface of the entire seal to ensure maximum
adhesion.
•
Allow at least 24 hours for the adhesive to fully cure. Evidence of tampering might not be apparent until the
adhesive cures.
NOTE
You should store any extra seals in a secure, temperature-controlled area.
Applying seals to Brocade FCX 624S-F, Brocade FCX 624S, and Brocade FCX 624S-HPOE
Use the figures in this section as a guide for security seal placement on the following Brocade FastIron devices:
•
Brocade FCX 624S-F
•
Brocade FCX 624S
•
Brocade FCX 624S-HPOE
The connectors on the faceplates of your particular device might vary from the connectors shown on the figures, but
the placement of the seals will be the same.
with seals as a model for the seal placement on the Brocade FCX 624S-F, Brocade FCX 624S, and Brocade FCX
624S-HPOE. Each of these devices requires the placement of 13 seals:
•
Top: Affix 4 total seals to the top panel of the device. Affix two seals so that they cover the left and right
frontmost screws on the top panel of the device. Affix two seals so that they cover the two screws adjacent to the
frontmost screws on the top panel. See
•
Right and left sides: Affix 4 total seals to the left and right sides of the device--two seals on the right side and
two seals on the left side. Each seal should cover two holes on either side of the first vent section. See
for correct seal orientation and positioning on the right side of the device. The orientation and placement of
seals on the left side mirrors the orientation and placement of seals on the right side of the device (visible in
Figure 1).
•
Front: Affix one seal horizontally-aligned with half affixed to the front panel and half affixed to the bottom panel.
You must bend this seal to place it correctly. See
4 of 13
Figure 1 on page 5 and
Figure 1 for correct seal orientation and positioning.
Figure 1 for correct seal orientation and positioning.
FIPS Security Seal Procedures for Brocade FCX Series and Brocade FastIron SX Series
Figure 2 on page 6 display a Brocade FCX 624S
Publication Number: 53-1002119-01
Figure 1