Brocade Communications Systems NetIron MLXe Series Hardware Installation Manual page 268

Replacing fan assemblies
3. Remove the fan assembly handle by detaching the two screws from the inside of the fan assembly faceplate using a Phillips
screwdriver, as shown in the following figure.
FIGURE 122 Handle removal
4. Orient the upward deflector on the fan assembly faceplate so that the exhaust will flow upward and the holes in the upward
deflector align with the holes where the screws secure the handle to the fan assembly faceplate. Refer to the previous figure.
268
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04