Brocade Communications Systems NetIron MLXe Series Hardware Installation Manual page 101

Follow these steps to connect a DC power source.
1. Use a #1 Phillips screwdriver to remove the two screws that hold the transparent cover over the power supply lugs, as shown in
one of the two following figures (dependent on the power supply).
FIGURE 31 The Brocade MLXe Series DC 1200W power supply
1. Screws holding transparent cover
FIGURE 32 The Brocade MLXe Series DC 1800W power supply
1. Screws holding transparent cover
2. Use a #2 Phillips screwdriver to remove the power lugs.
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04
Installing a Brocade MLXe Series-4 router
2. Power lug screws
2. Power lug screws
101