Related Commands; Troubleshooting Hardware; Configuration Terminal Display Failure; No Display On The Configuration Terminal - HPE FlexNetwork 10500 SERIES Troubleshooting Manual

Related commands

This section lists the commands that you might use for troubleshooting configuration loss.
Command
binary
copy
ftp
get
startup saved-configuration

Troubleshooting hardware

This section provides troubleshooting information for common hardware problems.
NOTE:
• This section describes how to troubleshoot terminal display, cards, power modules, and fan
trays. To troubleshoot transceiver modules, ports, and temperature alarms, see
system management" and
• For more information about the LEDs, see HPE FlexNetwork 10500 Switch Series Installation
Guide.

Configuration terminal display failure

No display on the configuration terminal

Symptom
The configuration terminal does not have display when the switch is powered on.
Solution
To resolve the problem:
1. Verify that the power system is operating correctly.
2. Verify that the MPU is operating correctly.
3. Verify that the console cable is connected to the console port or the USB console port on the
MPU and the specified serial port on the configuration terminal correctly.
4. Verify that the following settings are configured for the terminal:
Baud rate—9600.

Data bits—8.

Parity—None.

Stop bits—1.

Flow control—None.

Emulation—VT100.

5. Verify that the console cable is in good quality and is operating correctly.
6. If the problem persists, contact Hewlett Packard Enterprise Support.
Description
Sets the file transfer mode to binary.
Copies a file and saves the file to the destination directory.
Logs in to an FTP server and enters FTP client view.
Downloads a file from the FTP server and saves the file.
Specifies a file as a startup configuration file for each MPU.
"Troubleshooting ports."
15
"Troubleshooting