Snmp Trap Enable Stp - HP 3100 v2 Series Command Reference Manual

View
MST region view
Default level
2: System level
Parameters
level: Specifies an MSTP revision level, in the range of 0 to 65535.
Description
Use revision-level to configure the MSTP revision level.
Use undo revision-level to restore the default MSTP revision level.
By default, the MSTP revision level is 0.
The MSTP revision level, the MST region name, and the VLAN-to-instance mapping table of a
device determine the device's MST region. When the MST region name and VLAN-to-instance
mapping table are both the same for two MST regions, they can still be differentiated by their MSTP
revision levels.
After configuring this command, run the active region-configuration command to activate the
configured MST region level.
Related commands:
region-configuration, check region-configuration, and active region-configuration.
Examples
# Set the MSTP revision level of the MST region to 5.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] revision-level 5

snmp trap enable stp

Syntax
snmp-agent trap enable stp [ tc ]
undo snmp-agent trap enable stp [ tc ]
View
System view
Default level
3: Manage level
Parameters
tc: Specifies SNMP notifications for PVST topology changes.
Description
IMPORTANT:
This command is available on the HPE 3100 v2 EI switches.
Use snmp-agent trap enable stp to enable SNMP notifications for PVST topology changes.
Use undo snmp-agent trap enable stp to disable SNMP notifications for PVST topology changes.
By default, SNMP notifications are disabled for PVST topology changes in all VLANs.
instance, region-name,
106
vlan-mapping modulo, display stp