Bulk Interface Configuration Commands; Interface Range; Interface Range Name - HP 3100 v2 Series Command Reference Manual

Bulk interface configuration commands

interface range

Syntax
interface range interface-list
View
System view
Default level
2: System level
Parameters
interface-list: Specifies an interface list in the format of interface-list = { interface-type
interface-number [ to interface-type interface-number ] }&<1-5>, where &<1-5> indicates that you
can specify up to five interfaces or interface ranges. If you use the interface-type interface-number to
interface-type interface-number option to specify an interface range, make sure that all the interfaces
are on the same interface card or subcard, and the interface-number argument before to must be
less than or equal to that after to.
Description
Use interface range to create an interface range and enter interface range view.
You can use this command to enter interface range view to bulk configure multiple interfaces with the
same feature instead of configuring them one by one. For example, you can perform the shutdown
command in interface range view to shut down a range of interfaces.
In interface range view, only the commands supported by the first interface are available. To view the
commands supported by the first interface in the interface range, enter the interface range view and
enter ? at the command line interface prompt.
To verify the configuration of the first interface in the interface range, execute the display this
command in interface range view.
Failure to apply a command on one member interface does not affect the application of the
command on the other member interfaces. If applying a command on one member interface fails, the
system displays an error message and continues with the next member interface.
Examples
# Shut down interfaces Ethernet 1/0/1 through Ethernet 1/0/12, VLAN interface 1,
<Sysname> system-view
[Sysname] interface range ethernet 1/0/1 to ethernet 1/0/12 vlan-interface 1
[Sysname-if-range] shutdown

interface range name

Syntax
interface range name name [ interface interface-list ]
undo interface range name name
View
System view
48