Lacp Period Short - HP 3100 v2 Series Command Reference Manual

View
System view
Default level
2: System level
Parameters
interface-number: Specifies a Layer 2 aggregate interface by its number.
•
On the HPE 3100 v2 SI, the value range is 1 to 13.
•
On the HPE 3100 v2 EI, the value range is 1 to 9.
Description
Use interface bridge-aggregation to create a Layer 2 aggregate interface and enter the Layer 2
aggregate interface view.
Use undo interface bridge-aggregation to remove a Layer 2 aggregate interface.
When you create a Layer 2 aggregate interface, a Layer 2 aggregation group with the same number
is automatically created. If you remove the Layer 2 aggregate interface, you also remove the Layer 2
aggregation group, and any member ports will leave the aggregation group.
Examples
# Create Layer 2 aggregate interface Bridge-Aggregation 1 and enter its view.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1]

lacp period short

Syntax
lacp period short
undo lacp period
View
Ethernet interface view
Default level
2: System level
Parameters
None
Description
Use lacp period short to set the LACP timeout interval on a port to the short timeout interval (1
second).
Use undo lacp period to restore the default setting.
The default LACP timeout interval is the long timeout interval (30 seconds).
Examples
# Set the LACP timeout interval on Ethernet 1/0/1 to the short timeout interval (1 second).
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] lacp period short
75