HP 3100 v2 Series Command Reference Manual page 49

Field
Internet protocol processing
Physical is loopback
Last clearing of counters
Last 300 seconds input: 0 bytes/sec, 0
bits/sec, 0 packets/sec
Last 300 seconds output: 0 bytes/sec, 0
bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
The brief information of interface(s)
under route mode
Link: ADM - administratively down; Stby -
standby
Protocol: (s) - spoofing
Interface
Link
Protocol
Main IP
Description
State (enabled or disabled) of the network layer protocol
(displayed as Internet Address is X.X.X.X/XX Primary).
The physical type of the interface is loopback.
Time when statistics on the logical interface were last cleared by
using the reset counters interface command.
If the statistics of the interface have never been cleared by using
the reset counters interface command since device startup,
this field displays Never.
Average input rate during the last 300 seconds (displayed when
the interface supports traffic accounting), where the following
conditions apply:
•
packets/sec indicates the average number of packets
received per second.
•
bytes/sec indicates the average number of bytes received
per second.
•
bits/sec indicates the average number of bits received per
second.
Average output rate over the last 300 seconds (displayed when
the interface supports traffic accounting), where the following
conditions apply:
•
packets/sec indicates the average number of packets
sent per second.
•
bytes/sec indicates the average number of bytes sent per
second.
•
bits/sec indicates the average number of bits sent per
second.
Total number and size (in bytes) of input packets of the interface
and the number of dropped packets.
Total number and size (in bytes) of output packets of the
interface and the number of dropped packets.
Brief information about Layer 3 interfaces.
Link status:
•
ADM—The interface has been administratively shut down.
To recover its physical state, execute the undo shutdown
command.
•
Stby—The interface is operating as a backup interface.
If the network layer protocol state of an interface is shown as
UP, but its link is an on-demand link or not present at all, its
protocol attribute includes the spoofing flag (an s in
parentheses).
Abbreviated interface name.
Physical link state of the interface:
•
UP—The link is up.
•
ADM—The link has been administratively shut down. To
recover its physical state, perform the undo shutdown
command.
Protocol connection state of the interface, which can be UP,
DOWN, or UP(s).
The main IP address of the interface.
42