Gvrp Registration - HP 3100 v2 Series Command Reference Manual

Description
Use gvrp to enable GVRP.
Use undo gvrp to disable GVRP.
By default, GVRP is disabled.
Settings in system view take effect globally; settings in Ethernet view or Layer 2 aggregate interface
take effect on the current interface; settings in port group view take effect on all ports in the port
group.
To enable GVRP on a port, enable GVRP globally before you enable it on the port.
In interface view, you can use this command on trunk ports only.
You cannot change the link type of a GVRP-enabled trunk port.
Related commands: display gvrp status.
Examples
# Enable GVRP globally.
<Sysname> system-view
[Sysname] gvrp
GVRP is enabled globally.

gvrp registration

Syntax
gvrp registration { fixed | forbidden | normal }
undo gvrp registration
View
Ethernet interface view, Layer-2 aggregate interface view, port group view
Default level
2: System level
Parameters
fixed: Sets the GVRP registration mode to fixed.
forbidden: Sets the GVRP registration mode to forbidden.
normal: Sets the GVRP registration mode to normal.
Description
Use gvrp registration to configure the GVRP registration mode.
Use undo gvrp registration to restore the default.
The default GVRP registration mode is normal.
Settings in system view take effect globally; settings in Ethernet view or Layer 2 aggregate interface
take effect on the current interface; settings in port group view take effect on all ports in the port
group.
This command is only available on trunk ports.
Related commands: display garp statistics.
Examples
# Set the GVRP registration mode to fixed on port Ethernet 1/0/1.
<Sysname> system-view
179