Port Link-Type - HP 3100 v2 Series Command Reference Manual

Configuring Ethernet1/0/2... Done.
Configuring Ethernet1/0/3... Done.
The output shows that Ethernet 1/0/1, Ethernet 1/0/2, and Ethernet 1/0/3 are the member ports of the
aggregation group corresponding to Bridge-Aggregation 1.

port link-type

Syntax
port link-type { access | hybrid | trunk }
undo port link-type
View
Layer 2 Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
access: Configures the link type of a port as access.
hybrid: Configures the link type of a port as hybrid.
trunk: Configures the link type of a port as trunk.
Description
Use port link-type to configure the link type of a port.
Use undo port link-type to restore the default link type of a port.
By default, any port is an access port.
The configuration made in Layer 2 Ethernet interface view applies only to the port.
The configuration made in port group view applies to all ports in the port group.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and
its aggregation member ports.
•
If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
•
If the system fails to apply the configuration to an aggregation member port, it skips the port and
moves to the next member port.
To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to
access.
After you change the link type of an interface with the port link-type command, the loopback
detection action configured on the interface with the loopback-detection action command
automatically restores the default. For more information about the loopback detection action
configuration, see Layer 2—LAN Switching Configuration Guide.
Examples
# Configure Ethernet 1/0/1 as a trunk port.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] port link-type trunk
# Configure all the ports in the manual port group group1 as hybrid ports.
<Sysname> system-view
[Sysname] port-group manual group1
150