Garp Timer Hold; Garp Timer Join - HP 3100 v2 Series Command Reference Manual

Description
Use display gvrp vlan-operation to display information about dynamic VLAN operations on a port.
Examples
# Display information about dynamic VLAN operations on Ethernet 1/0/1.
<Sysname> display gvrp vlan-operation interface ethernet 1/0/1
Dynamic VLAN operations on port Ethernet1/0/1

garp timer hold

Syntax
garp timer hold timer-value
undo garp timer hold
View
Ethernet interface view, Layer-2 aggregate interface view, port group view
Default level
2: System level
Parameters
timer-value: Hold timer (in centiseconds), which must be a multiple of 5 and range from 10 (inclusive)
to half the Join timer (inclusive).
Description
Use garp timer hold to set the GARP Hold timer for an Ethernet port, Layer-2 aggregate interface,
or all ports in a port group.
Use undo garp timer hold to restore the default of the GARP Hold timer. This may fail if the default
is beyond the valid value range for the Hold timer.
By default, the Hold timer is 10 centiseconds.
Related commands: display garp timer and garp timer join.
Examples
# Set the GARP Hold timer to 15 centiseconds, assuming that the Join timer is 30 centiseconds.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] garp timer hold 15

garp timer join

Syntax
garp timer join timer-value
undo garp timer join
Operations of creating VLAN
Operations of deleting VLAN
Operations of adding VLAN to TRUNK
Operations of deleting VLAN from TRUNK
176
: 2-100
: none
: 2-100
: none