Mtu - HP 3100 v2 Series Command Reference Manual

undo ip address [ ip-address { mask | mask-length } ]
View
VLAN interface view
Default level
2: System level
Parameters
ip-address: Specifies an IP address in dotted decimal notation.
mask: Specifies a subnet mask in dotted decimal notation.
mask-length: Sets the number of consecutive 1s in the subnet mask, in the range of 0 to 32.
Description
Use ip address to assign an IP address and subnet mask to a VLAN interface.
Use undo ip address to remove the IP address and subnet mask for a VLAN interface.
By default, no IP address is assigned to any VLAN interface.
Related commands: display ip interface (Layer 3—IP Services Command Reference).
Examples
# Specify the IP address as 1.1.0.1, the subnet mask as 255.255.255.0 for VLAN interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ip address 1.1.0.1 255.255.255.0

mtu

Syntax
mtu size
undo mtu
View
VLAN interface view
Default level
2: System level
Parameters
size: Sets the maximum transmission unit (MTU), in the range of 46 to 1500 bytes.
Description
Use mtu to set the MTU for a VLAN interface.
Use undo mtu to restore the default.
By default, the MTU of a VLAN interface is 1500 bytes.
Related commands: display interface vlan-interface.
Examples
# Set the MTU to 1492 bytes for VLAN-interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] mtu 1492
141