Ethernet Link Aggregation Configuration Commands; Default; Description - HP 3100 v2 Series Command Reference Manual

Ethernet link aggregation configuration
commands

default

Syntax
default
View
Layer 2 aggregate interface view
Default level
2: System level
Parameters
None

Description

Use default to restore the default settings for an aggregate interface.
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of
the impacts of this command when you perform it on a live network.
This command might fail to restore the default settings for some commands for reasons such as
command dependencies and system restrictions. You can identify these commands by using the
display this command in interface view, and then use their undo forms or follow the command
reference to individually restore their default settings. If your restoration attempt still fails, follow the
error message to resolve the problem.
Examples
# Restore the default settings for Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] default
This command will restore the default settings. Continue? [Y/N]:y
description
Syntax
description text
undo description
View
Layer 2 aggregate interface view
Default level
2: System level
63