Lldp Compliance Admin-Status Cdp (Available Only On The Hpe 3100 V2 Ei) - HP 3100 v2 Series Command Reference Manual

Default level
2: System level
Parameters
interval: Sets the LLDP polling interval, in the range of 1 to 30 seconds.
Description
Use lldp check-change-interval to enable LLDP polling and set the polling interval.
Use undo lldp check-change-interval to restore the default.
By default, LLDP polling is disabled.
Examples
# Enable LLDP polling on Ethernet 1/0/1, setting the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] lldp check-change-interval 30
lldp compliance admin-status cdp (available only on the HPE
3100 v2 EI)
Syntax
lldp compliance admin-status cdp { disable | txrx }
undo lldp compliance admin-status cdp
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
disable: Specifies the disable mode. CDP-compatible LLDP in this mode cannot receive or transmit
CDP packets.
txrx: Specifies the TxRx mode. CDP-compatible LLDP in this mode can send and receive CDP
packets.
Description
Use lldp compliance admin-status cdp to configure the operating mode of CDP-compatible LLDP
on a port or port group.
Use undo lldp compliance admin-status cdp to restore the default.
By default, CDP-compatible LLDP operates in disable mode.
For your device to work with Cisco IP phones, you must perform the following tasks:
•
Enable CDP-compatible LLDP globally.
•
Configure CDP-compatible LLDP to operate in TxRx mode on the specified ports.
Related commands: lldp compliance cdp.
Examples
# Configure CDP-compatible LLDP to operate in TxRx mode on Ethernet 1/0/1.
<Sysname> system-view
203