Mrp Timer Leaveall - HP 3100 v2 Series Command Reference Manual

Default level
2: System level
Parameters
timer-value: Leave timer value (in centiseconds). The Leave timer must be greater than two times
the Join timer, less than the LeaveAll timer, and a multiple of 20.
Description
Use mrp timer leave to set the Leave timer.
Use undo mrp timer leave to restore the default.
By default, the Leave timer is 60 centiseconds.
You will fail to restore the default Leave timer if the default Leave timer is not greater than two times
the Join timer or not less than the LeaveAll timer.
Related commands: display mvrp running-status, mrp timer join, and mrp timer leaveall.
Examples
# Set the Leave timer to 100 centiseconds. (Suppose the Join and LeaveAll timer use their default
settings)
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] mrp timer leave 100

mrp timer leaveall

Syntax
mrp timer leaveall timer-value
undo mrp timer leaveall
View
Layer 2 Ethernet port view, Layer 2 aggregate interface view, port group view
Default level
2: System level
Parameter
timer-value: LeaveAll timer value (in centiseconds). The LeaveAll timer must be greater than any
Leave timer on each port, no greater than 32760, and a multiple of 20.
Description
Use mrp timer leaveall to set the LeaveAll timer.
Use undo mrp timer leaveall to restore the default.
By default, the LeaveAll timer is 1000 centiseconds.
You will fail to restore the default LeaveAll timer if the default LeaveAll timer is not greater than any
Leave timer on each port.
Each time when the LeaveAll timer of a port expires, all attributes of the MSTIs on the port are
deregistered throughout the network, and such a deregistration affects a large portion of the network.
Do not set too small a value for the LeaveAll timer, and make sure that the LeaveAll timer is greater
than any Leave timer on each port.
To keep the dynamic VLANs learned through MVRP stable, do not set the LeaveAll timer smaller
than its default value (1000 centiseconds).
220