Stp Point-To-Point - HP 3100 v2 Series Command Reference Manual

Default level
2: System level
Parameters
dot1d-1998: Configures the device to calculate the default path cost for ports based on IEEE
802.1d-1998.
dot1t: Configures the device to calculate the default path cost for ports based on IEEE 802.1t.
legacy: Configures the device to calculate the default path cost for ports based on a private
standard.
Description
Use stp pathcost-standard to specify a standard for the device to use when calculating the default
path costs for ports.
Use undo stp pathcost-standard to restore the default.
By default, the switch calculates the default path cost for ports based on a private standard.
If you change the standard that the device uses in calculating the default path costs, you restore the
path costs to the default.
Related commands: stp cost and display stp.
Examples
# Configure the device to calculate the default path cost for ports based on IEEE 802.1d-1998.
<Sysname> system-view
[Sysname] stp pathcost-standard dot1d-1998

stp point-to-point

Syntax
stp point-to-point { auto | force-false | force-true }
undo stp point-to-point
View
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
auto: Specifies automatic detection of the link type.
force-false: Specifies the non-point-to-point link type.
force-true: Specifies the point-to-point link type.
Description
Use stp point-to-point to configure the link type of the ports.
Use undo stp point-to-point to restore the default.
The default setting is auto and the spanning tree device automatically detects whether a port
connects to a point-to-point link.
Configured in Ethernet interface view, the setting takes effect only on the interface.
Configured in port group view, the setting takes effect on all member ports in the port group.
117